BTC Combo

Hain BTC:n sivuilta Combo aseman firmwaren päivitysohjeen, mutta en niistä mitään ymmärtänyt. Olisiko ketään, joka on kyseisen BTC BCO4016IM aseman päivittänyt (tai vastaavilla ohjeilla)? Tässä ohje:

"A. Flash firmware for DOS mode:
* IDE interface Drive: Before Flash Procedure, please make sure the following:
1. Build a boot disk (floppy) on Windows 98.
2. Unzip the firmware to the other one floppy disk.
3. Boot to DOS mode, and change the firmware disc.
4. If connect the drive to Secondary IDE Channel / Master. Please type "A:> FL 3".
5. If connect the drive to Secondary IDE Channel / Slave. Please type "A:> FL 4".
6. When it flashes to 100%, then finish. And restart computer.
* Warning! Flash program can't use on DOS mode of Windows!

B. Flash firmware for Windows mode:
1. Please download the appropriate driver file you need from this page.
2. Run the flash program under Windows.
3. Click on the ¡uUpgrade¡vbutton under the flash program
4. ¡uStatus Upgrading¡vis starting to flash the F/W
5. After flashing, the system will appear ¡uComplete¡IPlease restart your computer¡v, then, restart your computer to finish the flash procedure."
Oma käyttöjärjestelmä on XP.