Äänet hävöksissä.

Tämä ei löytäis mistään ajureita, et sais äänet pelaan.
Kortti vissiin integroitu, laitoin emon tiedot tähän jos
joku fiksumpi löytäs ne ...tanan ajurit jostain..

SiSoftware Sandra

Mainboard
Manufacturer : Pronix (Epox)
MP Support : 1 Processor(s)
MPS Version : 1.40
Model : Springdale-PE
System BIOS : 03/19/2004-Springdale-PE-6A79APAEC-00
Chipset : Intel 865/848 (Springdale)

System Memory Controller
Location : Mainboard
Error Correction Capability : None
Number of Memory Slots : 4
Maximum Installable Memory : 4GB
Bank0/1 - A0 : Empty
Bank2/3 - A1 : Empty
Bank4/5 - A2 : Empty
Bank6/7 - A3 : DIMM Synchronous SDRAM 512MB/64

Chipset 1
Model : Epox Computer Co Ltd 82865G/PE/P, 82848P DRAM Controller / Host-Hub Interface
Bus(es) : ISA AGP PCI IMB USB i2c/SMBus
Front Side Bus Speed : 4x 147MHz (588MHz data rate)
Maximum FSB Speed / Max Memory Speed : 4x 200MHz / 2x 200MHz
Width : 64-bit
IO Queue Depth : 12 request(s)

Chipset 1 Hub Interface
Type : Hub-Interface
Version : 1.50
Number of Ports : 3
Width : 8-bit
Full Duplex : Yes
Multiplier : 2/1x

Logical/Chipset 1 Memory Banks
Bank 6 : 256MB DDR-SDRAM 2.0-3-3-7 1CMD
Bank 7 : 256MB DDR-SDRAM 2.0-3-3-7 1CMD
Channels : 1
Speed : 2x 183MHz (366MHz data rate)
Multiplier : 5/4x
Width : 64-bit
Refresh Rate : 7.80µs
Performance Acceleration Technology : Yes
Power Save Mode : No
Fixed Hole Present : No

APIC 1
Version : 2.00
Multiplier : 1/2x
Maximum Interrupts : 24
IRQ Handler Engaged : Yes
Enhanced Support : Yes

Memory Module 1
Manufacturer : Transcend Information
Type : 512MB DDR-SDRAM
Technology : 16x(32Mx8)
Speed : PC3200U 2.5-3-3-8
Date of Manufacture : 25. joulukuuta 1999
Set Timing @ 200MHz : 2.5-3-3-8
Set Timing @ 167MHz : 2.0-3-3-7

Environment Monitor 1
Model : Winbond W83627(T)HF ISA
Version : 2.01
Mainboard Specific Support : No

Temperature Sensor(s)
Board Temperature : 28.0°C / 82.4°F
CPU Temperature : 46.0°C / 114.8°F td
Power / Aux Temperature : 35.0°C / 95.0°F

Cooling Device(s)
Auto Fan Speed Control : No
CPU Fan Speed : 3375rpm

Voltage Sensor(s)
CPU Voltage : 1.73V
Aux Voltage : 1.34V
+3.3V Voltage : 2.86V
+5V Voltage : 5.03V
+12V Voltage : 11.73V
-12V Voltage : -11.54V
-5V Voltage : -5.10V
Standby Voltage : 4.97V
Battery Voltage : 3.12V

AGP Bus(es) on Hub 1
Version : 3.00
Speed : 8x
Multiplier : 1/2x
Fast-Writes Enabled : Yes
Isochronous Mode Enabled : No
Addressing Enabled : 32-bit
Aperture Size : 256MB

PCI Bus(es) on Hub 1
Version : 2.20
Number of Bridges : 2
PCI Bus 0 : PCI (1/1x PCIClk)
PCI Bus 2 : PCI (1/1x PCIClk)

LPC Hub Controller 1
Model : Intel Corporation 82801EB/ER (ICH5/ICH5R) LPC Interface Bridge
ACPI Power Management Enabled : Yes
Delayed Transaction Enabled : Yes

LPC Hub Controller 2
Model : Epox Computer Co Ltd 82801EB/ER (ICH5/ICH5R) SMBus Controller

USB Controller 1
Model : Epox Computer Co Ltd 82801EB/ER (ICH5/ICH5R) USB UHCI Controller #1
Version : 1.10
Interface : UHCI
Channels : 2
Speed : 48MHz
Supported Speed(s) : Low (1.5Mbps) Full (12Mbps)
Legacy Emulation Enabled : No

USB Controller 2
Model : Epox Computer Co Ltd 82801EB/ER (ICH5/ICH5R) USB UHCI Controller #2
Version : 1.10
Interface : UHCI
Channels : 2
Speed : 48MHz
Supported Speed(s) : Low (1.5Mbps) Full (12Mbps)
Legacy Emulation Enabled : No

USB Controller 3
Model : Epox Computer Co Ltd 82801EB/ER (ICH5/ICH5R) USB UHCI Controller #3
Version : 1.10
Interface : UHCI
Channels : 2
Speed : 48MHz
Supported Speed(s) : Low (1.5Mbps) Full (12Mbps)
Legacy Emulation Enabled : No

USB Controller 4
Model : Epox Computer Co Ltd 82801EB/ER (ICH5/ICH5R) USB UHCI Controller #4
Version : 1.10
Interface : UHCI
Channels : 2
Speed : 48MHz
Supported Speed(s) : Low (1.5Mbps) Full (12Mbps)
Legacy Emulation Enabled : No

USB Controller 5
Model : Epox Computer Co Ltd 82801EB/ER (ICH5/ICH5R) USB 2.0 EHCI Controller
Version : 2.00
Specification : 1.00
Interface : EHCI
Channels : 8
Companion Controllers : 4
Supported Speed(s) : Low (1.5Mbps) Full (12Mbps) High (480Mbps)
Addressing Support : 64-bit
Legacy Emulation Enabled : No

System SMBus Controller 1
Model : Intel 801xx/63xx SMBus
Version : 0.02
Specification : 2.00
Advanced TCO Mode Enabled : No
Slave Device Enabled : Yes
PEC Support : No
Speed : 100kHz

Expansion Slot(s)
PCI0 (1h) : PCI 32-bit +5V PME Full-Length Available (Intel Corporation 82865G/PE/P, 82848P PCI-to-AGP Bridge)
PCI1 (2h) : PCI 32-bit +5V PME Full-Length Used
PCI2 (3h) : PCI 32-bit +5V PME Full-Length Available
PCI3 (4h) : PCI 32-bit +5V PME Full-Length Available
AGP (8h) : AGP 32-bit +5V Full-Length Used (ATI Technologies Inc Radeon 9550)

Port Connector
PRIMARY IDE : None - ATA / None
SECONDARY IDE : None - ATA / None
FDD : 8251 FIFO - Floppy Disk / None
COM1 : Serial Port 16450 - 9 Pin Dual Inline / DB-9 pin male
COM2 : Serial Port 16450 - 9 Pin Dual Inline / DB-9 pin male
LPT1 : Parallel Port ECP/EPP - DB-25 pin female / DB-25 pin female
Keyboard : Keyboard - PS/2 / PS/2
PS/2 Mouse : Mouse - PS/2 / PS/2
USB0 : USB - None / None
USB1 : USB - None / None

Performance Tips
Notice 224 : SMBIOS/DMI information may be inaccurate.
Tip 2511 : Some memory slots are free so the memory can be easily upgraded.
Tip 2546 : Large memory modules should be ECC/Parity.
Tip 2 : Double-click tip or press Enter while a tip is selected for more information about the tip.


Että tämmöstä..

 

En ole varma ymmärsinkö ongelmaasi oikein, mutta olisikohan codecit hukassa?? Täältä pitäisi kyllä löytyä kaikki kun valitset tuolta ylhäältä ohjelmat ja etit jonkun codec pakkauksen. Kun olet ladannut sen
niin sitten installoit sen.

Kokeiles installoida toi koneelle, jos vika on codeceissa:
http://fin.afterdawn.com/ohjelmat/video_ohjelmat/videocodecit/k-lite_mega_codec_pack.cfm

 

Laitehallinta näyttää kysymys- ja huutomerkkiä, eli taitaa ajurit puuttua.. Mut miepä kokeilen nuo codecit ensin..

 

http://www-old.epox.nl/english/products/motherboard/4pda2.htm
tuo emolevy nähtävästi kyseessä.
http://www.cmedia.com.tw/download/OS_e-cmi9739_index.htm
tuolta ajurit.