ADMtek AN983 ajurit..

Elikkäs siirsin tämmösesta fujitsu-siemensin marketti koneesta kyseisen verkkokortin vanhemmalle koneelle.. Kortin pistin paikkallee ja ajurien ohje oli tämmöne:

1. Go to the PCI configuration item in BIOS setup.

2. For legacy computers please follow the following steps to configure the
PCI slot:

a). You should know which slot your adapter is plugged in to. Look for
the physical location of the slot on your PCI motherboard.

b). Set the field that reads "this device" to "Enable".

c). Set the field that reads "this item" to "Master".
The FastNIC PCI adapter MUST be installed in an expansion slot
that supports "Bus Master" Refer to your system documentation to
determine which slots support Bus Mastering.

d). Some BIOS Setups allow you to select which interrupt line you can
use. In our case, select "INT A" for the field that reads "this
item".

e). Select an IRQ of your choice; make sure it does not conflict with
existing IRQs in use.

f). Select the "Trigger method" by which the IRQ is assigned or routed
to the PCI slot. Choose the "level-trigger" option.
Multiple FastNIC PCI adapters can share the same PCI interrupt and
all must use INTA with level-trigger mode.

3. Run the diagnostic program found in the driver diskette. If a problem
arises during the installation, contact your dealer or
Fast Ethernet Controller Provider Inc. for support.


Kun en oikeen tuota ymmärtänyt niin voisiko joku selventää mitä tarvis tehä? Emolevy on Asus km400 matx soc a, käyttis on WinME ja verkkokortti oli ADMtek AN983 10/100mbs PCI Adapter.